Curing Light
-Full-metal body, ergonomically-streamlined design, 108 g in weight
-Size of main uint: 23mm × 23mm × 204mm
-7 modes:
Normal, High, Turbo, Ortho, Soft, Pulse, Check
Normal mode:
Constant light intensity: 1000- 1200mw/cm²
Suitable for most treatment scenarios,such as fillings, restorations, etc.
Time setting: 5 s, 10 s, 15 s, 20 s
High mode:
Constant light intensity: 1800- 2000 mw/cm²
Suitable for quick curing, ensuring enough curing depth
Time setting: 3 s, 5 s
Soft mode:
Light intensity is gradually increased from 0 to 1200mw/cm²
Time setting: 5 s, 10 s, 15 s, 20 s
Effectively reduce the shrinkage rate of resin; Lower the risk of microleakage
Pulse mode:
The LED will stop for 0.4s at an interval of 0.6s curing
When working in a cycle of treatment, it can effectively reduce heat generation,efficiently dissipate heat and ensure the comfort of diagnosis and treatment.
Time setting: 5 s, 10 s, 15 s, 20 s
Check mode:
This mode outputs a single purple light, when special glasses are worn, the caries are obviously orange-red.
Application: detection of caries, calculus and cracked tooth
-Uniform beam: more focused light output thanks to light angle of only 15.8° ensuring good deep curing effect.
-Less light loss: the light intensity of curing light will be reduced when the curing distance increases.
-Charging base with built-in light meter: accurate light intensity is required for efficient polymerization of the resin
-360° rotatable head: easy to illuminate all angles in the mouth
-The low-profile head can easily reach the posterior teeth.
-Wide spectrum curing light can cure all resin materials:
Camphorone (CQ) is used as photoinitiator in most of the resins on the market, but some resins use two kinds of new photoinitiators, i.e. TPO or ivocerin.
The main absorption wavelength of these three kinds of resins is 385-515mm
O-Star is suitable for effective curing of most resins on the market.
-Light intensity up to 3000MW/cm²: the high light intensity brings sufficient curing depth, which can reduce the curing time and greatly improve the efficiency of resin curing.
-Equipped with 10wLED
